obj2obj now ready

#93196

By jaz11 - Mon Dec 05, 2005 6:43 pm

- Mon Dec 05, 2005 6:43 pm #93196

Thanks hrothgar.

Does this do proper smoothing of curves (without the faceting)??

I'll give it a try, but I actually had pretty good luck using .3ds export too.

Thanks again.

#94962

By Sheik - Wed Dec 07, 2005 3:59 pm

- Wed Dec 07, 2005 3:59 pm #94962

Thanks Hrothgar,
I just got RC2 running and I will give it a try. It is nice to see you here.
Any ideas on how we could use the Maxwell material editor from inside SketchUp, or on how to launch the preview from SketchUp? Do you think it would be possible to link SU materials with mxm materials (like you did in 3ds2mxs)?
I would much prefer not to use Maxwell Studio…
Sheik