[Antonella Zaccarelli 20210409152108]

I'm not a Maxwell expert, but I don't know where I clicked, because all the plastics have turned dark red and the metals dull grey.
I noticed that in all the materials, after this event, "Global Property" is set to Referenced and setting this value to Custom, the plastics are back in place, but not the metals, which I have to go to reset some parameters. What could have happened?
Thanks
Antonella

[Mark Bell]

Have you tried searching through the archives to see if there has been a similar issue in the past?

[Antonella Zaccarelli 20210409152108]

Yes I have tried, but to no avail.
I have Rhino 7.0 and Maxwell 5.2 so I don't think I would find anything by looking too far back.

Thank you

[Mark Bell]

Some other suggestions -
1. try doing a SaveAs to a new file and see if the problem recreates in the newer file.
2. open a new blank drawing and place that side by side with the current one and compare settings in the various menus starting with the camera and materials menus.
3. It's not clear if the problem is in the rendered image or in the material browser. Perhaps also reload materials again or use the wizard to create a new material of similar type and see if the problem persists?
4. Submit a ticket to NL for help

[Antonella Zaccarelli 20210409152108]

Thank you for your attention and advice.

I will try ...