Not there yet? Post your work in progress here to receive feedback from the users.
By acrighton
#383996
Hi,

Looking for some guidance about removing the colored spots evident on the trawler in this image. SL was ~18.5, adjusting via Multilight won't eliminate the spots. Physical sky and sun were used, along with two offset emitters to illuminate the front a little. Port & starboard emitters were used (green & red) which I think may have caused this. Taking those emitter values down to zero has no effect on the bright colored spots.

Any ideas what would cause this, and how I can avoid it? Any help/guidance would be much appreciated.

Regards
Alan

[img][IMG]http://i871.photobucket.com/albums/ab27 ... 32f878.jpg[/img][/img]
User avatar
By Jozvex
#384244
Are you using any Coatings in your materials?

That's typically the only time I get spots like that. I'm not sure how to resolve it aside from not using coatings. :?
Sketchup 2025 Released

Thank you Fernando!!!!!!!!!!!!!!!!!!!!!!!!!!! hwol[…]

I've noticed that "export all" creates l[…]

hmmm can you elaborate a bit about the the use of […]

render engines and Maxwell

Funny, I think, that when I check CG sites they ar[…]