All posts related to V2

Should we remove material snapshots?

I don't care, never use it
27
37%
I use it occasionally, but wouldn't mind if it's removed
3
4%
I use it occasionally, but I would prefer to keep it
18
25%
I use it often, don't remove it!
25
34%
#370232
Didn`t know it exist, and that it is working this way - 1. store, 2. arows. Since it is stored, it can be used as "undo","redo" options, that I like on every software. So I voted for better keeping it. I will not use it massively.
May be little out of theme, but sometimes when I refresh material preview, it will not refresh, or sometimes it is just cyan ball as if it was emitter or sss there, and it is "stored" corrupted. Even after another refresh, where preview is ok, there is stored corrupted image preview.

Patrik
#370259
PA3K wrote:Didn`t know it exist, and that it is working this way - 1. store, 2. arows. Since it is stored, it can be used as "undo","redo" options, that I like on every software. So I voted for better keeping it. I will not use it massively.
May be little out of theme, but sometimes when I refresh material preview, it will not refresh, or sometimes it is just cyan ball as if it was emitter or sss there, and it is "stored" corrupted. Even after another refresh, where preview is ok, there is stored corrupted image preview.

Patrik
Yes, that cyan ball. I know it too.
Happens only with std.preview scene here though.
Try stage 2 or so. It should render ok.
I always ignored it, as the material itself still renders ok in the scene.

after a lot of years doing arch-viz... almost 20 a[…]

render engines and Maxwell

Funny, I think, that when I check CG sites they ar[…]

Hey, I guess maxwell is not going to be updates a[…]

Help with swimming pool water

Hi Choo Chee. Thanks for posting. I have used re[…]