[Asmithey]

Hi,

I am doing a top orthographic view of a project. When I render it in top view, as you can see in the attached image, I get a bunch of strange artifacts. I do not get these in the perspective view. As always, I am about 99.99% sure it is operator error. But I can not pin it down.

NL, I can pack and go and send it to you if interested.

Thanks,
Aaron

[Bubbaloo]

I always set up a camera to approximate ortho views because of these issues. Just move your camera FAR away and zoom in close. Even doing this, I still see triangulation/shading issues sometimes, especially from poorly modeled Revit/Sketchup stuff. I either remodel the bad parts in quads, or touch up in PS later.