[kami]

Hi Jeremy
Sorry to bother you with a rhino5 issue, but I got a major problem with the latest wip.
Every new object I create (except for meshes) is not rendered. In a new file I get the message: "Maxwell: there are no objects to render"
Do you know any workaround for this?
Thanks
Kami

[JDHill]

Are you using the new 'Extrusion' objects?

[kami]

just by accident ... it must have been enabled by default. I changed it back to polysurface and it works now
thank you very much !!!!
I didn't know about this new feature. Looks interesting because I noticed that a lot of polysurfaces made rhino very slow

[Josephus Holt]

Interesting...I would assume that you're holding off with updating the plugin until McNeel decides which way to go with these lw extrusions?

[JDHill]

In theory, a plugin should not be concerned with this. I haven't personally tested them, so I can't comment on if/why they are not working, but I would expect them to begin working in some upcoming WIP.

[val_z]

just by accident ... it must have been enabled by default. I changed it back to polysurface and it works now
thank you very much !!!!
I didn't know about this new feature. Looks interesting because I noticed that a lot of polysurfaces made rhino very slow

how to chech back to polysurface??
I get message "there is no object to render"

[JDHill]

In the command line, type UseExtrusions, then click Polysurface. To turn them back on, do the same, but select Extrusion.

[val_z]

thanks.