[simmsimaging]

Hey all -
I've read a lot of posts for fireflies with the new Mac version, but I'm having problems with them in Max as well. Particularly obvious with co-op renders.

There are a lot of transparent/glassy objects in the scene - not sure if they would class as dielectric or not.

Anyone else seeing this problem? Is it something that is going to be fixed in all versions or just the Mac one?


Thanks
b

[sandykoufax]

http://www.maxwellrender.com/forum/view ... 008#206008

trivial but pesky.

[sandykoufax]

I don't know it's already reported

The maximum value of offset in the image based env. is not the same with studio.

In the plugin, the maximum value is just 1.0
In the Studio, it's a 100.

[Bogdan Coroi]

Thanks. It will be fixed.

[sandykoufax]

in the 1.5.6 version.

AGS wizard has still bug.

When I select AGS,

default roughness value is 100 in the plugin while 0 in the MXED.

and there is two reflective basis layers.

I thing the first layer is not a reflective basis but a refractive basis.

[Bogdan Coroi]

I never saw this mentioned in the 3dsMAX forum. But be sure it will be fixed. Thanks.

[tanguy]

When you change the layers % for one layers it fix the same % form the second...

Is it normal ?

[tanguy]

Then it is possible but only with a use of the scroll
Or cause a map is load in the Layer blending...

[Bogdan Coroi]

I'm not sure I follow you. Could you please describe it a little bit?

[tanguy]

I create a new mxm, then i make a multi layers.
I tune my first layer and after a create a second layer. Then i need to blend the both layers with 2 ways... first with the numeric value and second with map blending. So if i put the value 65 in the second layers blend it put in the same time the same value on the first layer blend aerea. and if i change one of them it change the both like 65 65 or 40 40...
No possibility to make a 60 40 by exemple.
I can make it if i use the up and down arrow you place at this effect. I f a enter the value it appear what i describe up.
But maybe it s because i try to use a map for the blend... I have no time to test what parameter unblock the prooblem.
I use a XP 64 sys with Xeons on 604. MX 1.5 with the new one Max plug 1.5.6

Cordially

[Bogdan Coroi]

The value you manually enter in an editbox is not saved until the editbox control loses focus. You can lose the focus by pressing the TAB key after you finish entering your values.

[Mihnea Balta]

This thread is much too big and it's very hard to follow issues in it so I will close it. From now on, please make one thread for each problem report.

Thanks,
Mihnea