Everything related to http://resources.maxwellrender.com
User avatar
By Ric_535
#196092
Hi, been trying to make a material similiar to the objects in the pics below

Image


my attempt so far is pretty poor :(

Image


Can anyone help suggest something to improve my efforts?

Cheers! Ric
User avatar
By Thomas An.
#196093
The objects in the pictures look hollow ... which brings the question: Is your modeled object also hollow ?
User avatar
By Ric_535
#196095
Hi, i just thought that after posting, apparently the plastic is 1mm thick so i have extruded the object by that amount (with create caps checked - in C4D)

I'll try rendering again but my material still isn't right

Cheers, Ric
User avatar
By Tim Ellis
#196188
I presume these are cut and folded from one flat sheet, of the 1mm plastic. You could recreate it with 3 pieces, two sides and the wrap round section.

You'll need to at least join the sections that make up the wrap round section, to stop the light escaping at the joins.

Try with an attenuation of 2mm for the 1mm plastic, if they are now 1mm solid walls instead of a solid object.

Hope this helps,

Tim.
Sketchup 2025 Released

Thank you Fernando!!!!!!!!!!!!!!!!!!!!!!!!!!! hwol[…]

I've noticed that "export all" creates l[…]

hmmm can you elaborate a bit about the the use of […]

render engines and Maxwell

Funny, I think, that when I check CG sites they ar[…]