- Thu Nov 16, 2006 11:03 am
#195637
I made a model with flipped or mirrored emitter planes and found in Maxwell that the originals where alright but the flipped ones the surfaces where reversed and so did not work. I haven't tried this but I thought of this workaround by making al my emitters cut in half with surfaces directing both ways using a component that restricts light going only in one direction.
Anyone experienced the same problem.
I had very good experiences with making spotlights with using a cilinder with an emitter surface at the bottom and the inside of the cilinder black. This way I get a very nice typical spotlight I can adjust by moving the emitter plane up and down in the cilinder. I use this cilinder in all sort of light fixtures.
Anyone experienced the same problem.
I had very good experiences with making spotlights with using a cilinder with an emitter surface at the bottom and the inside of the cilinder black. This way I get a very nice typical spotlight I can adjust by moving the emitter plane up and down in the cilinder. I use this cilinder in all sort of light fixtures.