[Miles]

The Studio STL importer assumes a unit of meters. Is this a bug?

See post 12 in this thread: http://www.maxwellrender.com/forum/view ... 89&start=0

Miles

[Miles]

I still have this problem with V1. I have to scale down STL files by a factor of 1000...

[glypticmax]

Same here. Finger rings show up the size of starships.

[Miles]

Let's hope all the scaling issues are sorted for version 1.1 ....

[Miles]

No change with 1.1

It's a bore but I can, of course, change the units setting of every part file before exporting - the trouble is, if I do this, on import the Maxwell grid gets set to multiples of 1.95312mm

Nice to get this sorted for 1.2.......

Miles