- Thu Dec 08, 2005 5:49 pm
#95994
Hi there,
I'm so happy for the C4D plug!
But I think I found a buggie.
I have the impression (not too much time to check it thoroughly) that if you assign a material to a Extrude NURBS object with more than one splines (hierarchical mode), the M~R material doesn't get applied.
Can anybody check it?
Thanx!
I'm so happy for the C4D plug!
But I think I found a buggie.
I have the impression (not too much time to check it thoroughly) that if you assign a material to a Extrude NURBS object with more than one splines (hierarchical mode), the M~R material doesn't get applied.
Can anybody check it?
Thanx!
my site: http://www.gocrazycreative.com