[insomnia3d]

Ok, so Cooperative rendering works fine, except for a couple of times and the next big task is Cooperative+Multilight. I have done the same scene over and over, checking and unchecking, mxi after mxi. It works fine if i do it frm a single computer, say from max by checking the box. Yet when i do Cooperative...no way.
May be i can get the attention of one of the A-Team members, cause even though i might trip on the awnser by mistake after a couple of days, its getting pretty damn frustrating. Here, like Pete, would like to send a scene to render Cooperatively without having to stop it 20 times in order to check.

So please someone let me know wtf i am doing wrong...

Maxer, i think Peter and I deserve a spot on your B-Team.

[insomnia3d]

That's a must,
Trust me with the mscl.exe -d -ml, i have done every type of combination checking and unchecking boxes... and nothing. The only mention in the manual is...
"When using the advance tool, multilight should be disabled"

[insomnia3d]

Ok, we are getting somewere....
Were in that line of comands would -ml go at...begining or end.....?

[insomnia3d]

Now, if i use the mxcl.exe -d -ml, i am assuming that its arguing for that.
simple, just as Dennis said. whensubmitting Job at the end of the argument add : -ml

Why couldn't all this be on the manual... (it only tells you to do it once, on the mxcl.exe not on the Job submitt.)
Lets see ehat is next...

[Maxer]

insomnia3d your welcome aboard the B-team, hope you have better luck than I'm having.

[insomnia3d]

It's getting there my friend...so far on two days without sleep i have the network rendering and the network rendering with multilight...and...that's all.
I would have never thought this was going to be such an intensive experience.

Thanks for the B-Team invitation, i just saw Tom's post and it seems like patches are comming, after they see what we are breaking our heads with and then wait till we figure out our own mistakes...

Just Kidding Tom...(not really) but i know you understand our frustration.