Newly designed yoke for flight simulation

Reply

Newly designed yoke for flight simulation#401561

By NicoR44 - Thu Dec 22, 2022 10:08 am

- Thu Dec 22, 2022 10:08 am #401561

Hi all, here a new yoke I made in Solid Works, to be die casted in a silicone mold.
overall Thickness is 7mm, rendered in green glass using the default Maxwell studio, light setup studio

Cheers, Curt.

Render time on my system about 16 hours

Last edited by NicoR44 on Thu Dec 22, 2022 11:51 am, edited 1 time in total.

Curt Roth, formally known as NicoR44.

Re: Newly designed yoke for flight simulation#401562

By NicoR44 - Thu Dec 22, 2022 10:56 am

- Thu Dec 22, 2022 10:56 am #401562

Screens from SolidWorks:

Curt Roth, formally known as NicoR44.

Re: Newly designed yoke for flight simulation#401563

By NicoR44 - Thu Dec 22, 2022 11:06 am

- Thu Dec 22, 2022 11:06 am #401563

Curt Roth, formally known as NicoR44.

Re: Newly designed yoke for flight simulation#401565

By choo-chee - Thu Dec 22, 2022 4:58 pm

- Thu Dec 22, 2022 4:58 pm #401565

very nice materials

ahh....ahhh....ahhh......no !!

Re: Newly designed yoke for flight simulation#401566

By Mark Bell - Fri Dec 23, 2022 12:36 am

- Fri Dec 23, 2022 12:36 am #401566

Well done - the green-glass renders explain the proposal clearly. Good work. Out of interest, what was the SL you rendered to?

Re: Newly designed yoke for flight simulation#401570

By Forum Moderator - Tue Dec 27, 2022 1:46 pm

- Tue Dec 27, 2022 1:46 pm #401570

Very nice and clean, Nico!

I'd say that he's using some big emitters and we are not seeing the full-res render so, most probably, it only went up to SL 16-17.

Fernando

Fernando Tella.

Customer Portal: https://portal.nextlimit.com - Documentation: https://nextlimitsupport.atlassian.net/ ... !spacehome