Angle map for cylinder top?

Angle map for cylinder top?#297415

By jvanmetre - Mon May 04, 2009 5:38 pm

- Mon May 04, 2009 5:38 pm #297415

I'm trying to create the correct look for an aluminum cylinder...following some old posts about angle maps, not sure what they are and where
they go.

Thanks

jvm

Re: Angle map for cylinder top?#297441

By jvanmetre - Mon May 04, 2009 9:27 pm

- Mon May 04, 2009 9:27 pm #297441

Okay...here are the cylinders...I'm using a radial blur in the reflective channel only. Suggestions for making it more realisitic much appreciated.

jvm

Re: Angle map for cylinder top?#297452

By Maximus3D - Mon May 04, 2009 10:43 pm

- Mon May 04, 2009 10:43 pm #297452

I think it looks pretty good already, perhaps a bit more reflectivity but not too much because you wanna keep some of that blurriness. Here's my test, but it's no way near perfect yet.

Roughness 16

Roughness 8

/ Max

http://www.fotografmagnus.se/
https://www.facebook.com/FotografMagnusRonnkvist

Re: Angle map for cylinder top?#297464

By jvanmetre - Tue May 05, 2009 1:00 am

- Tue May 05, 2009 1:00 am #297464

Max-

Thanks for the feedback...is your map in reflective channel only? Will try adjusting roughness.

jvm

Re: Angle map for cylinder top?#297465

By Maximus3D - Tue May 05, 2009 1:06 am

- Tue May 05, 2009 1:06 am #297465

You're welcome, no my maps are placed like this which from what i can see in your rendering. Your maps appears to be the same as mine. The bumpmap is obviously the same as the anisotropymap.

Anisotropy map