Are you sure about that on the lower piece ? ... I do not see any draft angle in that area (the one you point from 1.00 to 1.32mm). It is 1.3 all the way down here on my sample.NicoR44 wrote:Ah ok, I found some here in the lower part:
Are you sure about that on the lower piece ? ... I do not see any draft angle in that area (the one you point from 1.00 to 1.32mm). It is 1.3 all the way down here on my sample.NicoR44 wrote:Ah ok, I found some here in the lower part:
oh yes, and 
Measured again, but still do not see it. When I put the caliper at the very top of that wall, then it slides all the way down. If there was a draft there it would not do this.NicoR44 wrote:measuring it again, yes very much so, and seeing it from the side it is visible.
I'll try and make some close-ups tomorrow
Yeah, I am beginning to suspect so (mine has a number R1024). Also, in your screen grabs earlier for the bottom piece ... there are two rectangular grooves on the right hand side at the base and there is one groove on the left. My model does not have the groove on the left (you can see this difference in my screen grab of that part)NicoR44 wrote:I think we have slightly different models, aaaarrrgghh, I had to get the hard one
I have a number here at the inner part JC11-2, but it doesn't say who or where it was made
Must try to learn more nurbs modeling....
- By jurX