- Wed Oct 17, 2007 12:06 pm
#247096
heya.
is there any plausible way to export the correct 3d information from archicad, so that the materials stay selectable?
a client uses archicad and exported: .obj, .dxf, .dwg but none of these files opens correctly in any piece of software. especially window frames and glass planes should be selectable of course since the facade will be made in concrete.
best solution would be to export poly clouds as independent models from archicad for each material, but i guess that 10'000 $ piece of shit software cannot do this.
any help on this around ?
is there any plausible way to export the correct 3d information from archicad, so that the materials stay selectable?
a client uses archicad and exported: .obj, .dxf, .dwg but none of these files opens correctly in any piece of software. especially window frames and glass planes should be selectable of course since the facade will be made in concrete.
best solution would be to export poly clouds as independent models from archicad for each material, but i guess that 10'000 $ piece of shit software cannot do this.
any help on this around ?
- By choo-chee
- By Mark Bell
- By Forum Moderator