[juan]

Hi,

We are preparing the final details for the release, the first days of the next week.

Kind regards,

Juan

[rockguy]

Just the announcement that the new plug-in would be released soon.

The new plug-in was also on display. It looked really nice and quite a bit nicer than the old plug-in. The use seemed more stream lined and you have direct access to the MXM materials (editing) as well as drag and drop application and a history tree showing where thay have been applied. My only dissapointment was the lack of support for decals. I understand this is a SW limitation and if the controls were there Next Limit could add the control to the plug-in. After talking with Next Limit and SolidWorks it sounds like the two companies are working together to iron out the issues. I think it's just a matter of time.

No doubt Next Limit has put some great work and time into the new plug-in.

[jjs]

Thanks Rob and Juan - look forward to getting the mail

TTFN

Jonathan