[jka]

Sometimes its necessary to work in Studio after completing the model in ArchiCAD. However, the model usually undergoes many changes.
Is there anything like using a reference file in maxwell? Lets say I have my model exported from Archicad, make a few adjustments in Studio (that take some time) and render. Then, the model i slightly changed, I have to go to Studio again and perform all those little adjustments once again. I was wondering if theres a way to avoid that - just send the changed model to Studio and tell it to use the older Studio file with all the adjustments set (like changing some materials lights etc)?
Such a thing works well with Artlantis.
Is there such a thing in Maxwell? Or do I have to spend hours and hours on adjusting the scene in Studio every time I make a slight change in the model?

[Marton Day8]

Sorry, it is not possible.

But with the new plugin you can set most of the parameters inside ArchiCAD so you hopefully don't have to do many changes inside Studio.


Márton