Export Problem

By w i l l - Fri Dec 21, 2012 2:54 pm

- Fri Dec 21, 2012 2:54 pm #363834

When I export an assembly the parts are all over the place... it's fine in Solidworks. Any ideas what the problem might be? Thanks

By JDHill - Fri Dec 21, 2012 2:57 pm

- Fri Dec 21, 2012 2:57 pm #363835

Which version of the plugin are you using -- there was a problem with it in some versions prior to 2.7.10.

Next Limit Team

By w i l l - Fri Dec 21, 2012 6:53 pm

- Fri Dec 21, 2012 6:53 pm #363843

Thanks for the tip. I updated it, it's working now.

Jump to:

28 May

- By Forester

Hello Mark! Very good tips about the camera setti[…]

24 May

- By Mike Amos 20240524151621

https://community.sketchucation.com/category/49/wi[…]

24 May

- By Mike Amos 20240524151621

Sadly, this lack of a response demonstrates a mori[…]