By Rendo
#349269
I have created a Motion study and tried to render, however none of the animated parts are moving after they have been exported to Maxwell.
(All the MXS/MXI etc are being generated).

The preview in Solidworks shows everything moving as it should and the camera pans in Maxwell as per the preview. Has anyone else come across this problem?

Software versions are:
SoildWorks 2011 SP5.0 (the same problem in SP4.0) x64.
Maxwell 2.6.0.0 with Plugin 2.6.0.0

Turn-table animation works fine.

- Matt
By Rendo
#349650
I know that you have a million other jobs to sort, but did you get any luck with a work around for the motion study? I have a job that would be ideally suited to this.

Would uninstalling the 2.6.0.0 plugin and using the previous one cure the issue for now?

- Matt
Materials translucent with V5.1

Well, the problems can be in the chair, the monito[…]

hardware question :)

That’s a point to resolve fast. Other rend[…]

For me a lot of Maxwell is about the time saved se[…]

New podcast - CG Talks

Hey guys! We have just finished the second season[…]