[Left Side]

Hi,

We seem to have a problem with the camera angle / lens size in Fire is not the same as set in the Rhino viewport, as below.

Using 2.7.20, any ideas??

Thanks,

[JDHill]

The angle seems odd, but the film size does not match what the viewport will show (24mm high), so first try switching to the Viewport preset in Output Resolution, and then re-setting the output width or height. If the angle is still off, I would need you to send me (jeremy at nextlimit dotcom) a copy of the file, or upload it to dropbox or similar, so I can see what's happening.

[polynurb]

i noticed a few times (means 3 or so) that the fire window will not immediately pick up the changes i do in shift xy or filmsize;
i think it happened after some combination of locking fire to a view and jumping back forth in the rhino viewports...

it helped to reset to "viewport" in the resolution slot in such a case.

[Left Side]

Great,

Thanks for your tips, I'll try this out and report back


Thanks again

[JDHill]

There has been some work in this area in 2.7.25, so please let me know if you are still able to observe any problems here.