[kami]

Hi once again
I sometimes got problems adjusting a custom mesh for displacement:

Why are the planar faces nicely meshed into 5x5cm and the curved wall isn't? The mesh is not split horizontally there.
Thanks for the help.
Cheers, kami

[Polyxo]

Is this Rh5 Beta? If yes it is a known bug of the current mesher to disregard the aspect ratio settings.
You might try the TestNewmesher Command - it allows you to use the old mesher instead.

[kami]

thx a lot. that has worked. didn't know about the issue.

[JDHill]

You might try the TestNewmesher Command - it allows you to use the old mesher instead.

Orwellian.