[gtalarico]

I am trying to add a scene to monitor do a coop render.
After adding the MXS, monitor is not picking up all the scene data such as cameras, dimension, channels, etc.

Any suggestions?

[gtalarico]

It's lonely out here.... : )

[frosty_ramen]

odd tip.
try saving as a new file and then pack&go and try to add the coop again

[Bubbaloo]

Are there multiple cameras in the scene? Try deleting all but the active camera, then save an MXS to render through the coop network wizard. I believe there is a bug that affects the reading of camera parameters if there is more than one camera in the scene.

[gtalarico]

Gave up on network rendering for the time being (out of time!)
Next time I run into this problem I will try your suggestions and post back.

Thanks

[gtalarico]

Figure out what was wrong... my SU plugin version and maxwell version did not match the version installed in nodes.
Once installed the same version across the entire maxwell ecosystem things went smoothly.