OBJ to Solid converter

#271679

By b-kandor - Wed Jun 04, 2008 1:41 pm

- Wed Jun 04, 2008 1:41 pm #271679

Cool, nice link!

I don't think that was the same one - the only things I remember about the one I used was: the company was in michigan and it cost around 3.5k - so I never bought it at the time!

Thanks,

Kandor

#272024

By mtripoli - Sun Jun 08, 2008 7:12 am

- Sun Jun 08, 2008 7:12 am #272024

I tried the "Poor persons" stuff... damned ifI could get anything useful out of it... I don't mind putting in the work but if it takes more than half an hour I'll re-model it... someday.... just someday....

The most exciting phrase to hear in science, the one that heralds new discoveries, is not "Eureka!" but "That's funny ..."
Isaac Asimov