- Fri May 24, 2013 5:51 pm
#368103
Hi
I am trying to map a decal to a mesh speaker grille. The only issue is that the decal is fully opaque....how do I map it so that it follows the same transparency as the hole pattern? Below is the material screen grab. The decal layer is applied as a 100% weight map with normal layer blending. Thanks!
I am trying to map a decal to a mesh speaker grille. The only issue is that the decal is fully opaque....how do I map it so that it follows the same transparency as the hole pattern? Below is the material screen grab. The decal layer is applied as a 100% weight map with normal layer blending. Thanks!