Page 1 of 1
Network renders not merging on new computer build
Posted: Wed Apr 03, 2013 7:35 am
by itsallgoode9
Anybody have suggestions about this? I just built a new computer and now I cant get any of my network renders to merge. It worked fine on the old computer but now everytime I render I just get an error that says "failed" then it opens up the folder which shows all of the render files. I can manually merge these but obviously this is just a work around until i figure out what is going on.
Any thoughts on something that I might have missed when setting up the new computer would be appreciated.
Re: Network renders not merging on new computer build
Posted: Wed Apr 03, 2013 7:54 am
by itsallgoode9
i just noticed there is an error in the network manager that says "The MXI files sources don't match " but i'm not sure what that means exactly.
Re: Network renders not merging on new computer build
Posted: Wed Apr 03, 2013 9:13 am
by Mihai
Are you sure all computers are running the same version of Maxwell and Network?
Re: Network renders not merging on new computer build
Posted: Wed Apr 03, 2013 5:47 pm
by itsallgoode9
just checked them and they're all on 2.7.20.0
Re: Network renders not merging on new computer build
Posted: Thu Apr 04, 2013 12:43 am
by Mihai
In that case I can just think that there might have been some older MXI files in the temp folders and it's trying to merge with those...
Re: Network renders not merging on new computer build
Posted: Thu Apr 04, 2013 8:09 am
by itsallgoode9
I'll try deleting those and maybe it'll work. Not in front of the computer now but I'll give it a try in the morning. Thanks for the suggestion mihai