All posts related to V2
User avatar
By macray
#365143
Hi there,

I wanted to create a multilight animation but it seems like Maxwell is always exporting the same frame without changing the light intensities.

for the test I setup a cube and 3 light emitters around, activated multilight, rendered the picture, stopped the render, then changed the multilight values at the beginning, the middle and the end. I made sure keyframe were created and when playing the animation it was shown in the small peview window.

Now i used the 'save sequence' from the multilight option toolbar and as many pictures were exported as I had frames arranged. During the export Maxwell went from one frame to the next, each time I could see the sliders in the multilight tab change accordingly but when checking the exported pictures ALL of them showed the very first frame - so each picture is the same.


What do I do wrong or what has to be changed to make it correct and export each picture with a different light setup as it should?
Sketchup 2025 Released

Thank you Fernando!!!!!!!!!!!!!!!!!!!!!!!!!!! hwol[…]

I've noticed that "export all" creates l[…]

hmmm can you elaborate a bit about the the use of […]

render engines and Maxwell

Funny, I think, that when I check CG sites they ar[…]