Page 1 of 1

Adding nodes back to a job

Posted: Sat Nov 03, 2012 7:10 pm
by druitres
Hello,

I haven't found a way yet to bring back/re-enter a node to a running job. I can 'release nodes'. Is there a way to 'add nodes'? Or to have Maxwell autodetect whenever a node becomes available (during running jobs, that is)?

Thanks, Jasper

Re: Adding nodes back to a job

Posted: Mon Nov 05, 2012 11:50 pm
by Bubbaloo
Highlight a node and the job, then push the Add Node button. It should work, but I've never tried releasing a node, then re-adding it.