Page 1 of 1

Maxwell Render - Interface Windows Setup Problem

Posted: Fri Oct 12, 2012 1:53 pm
by Q2
Hi guys,

I seem to have a problem with the interface when I start up Maxwell Render. It doesn't seem to remember the preferences (the way I set up the interface the last time before I closed the software), so when I reopen the software, all settings boxes and windows are closed. That means each time I have to go under 'Window' and manually check all items. ( Multilight, Camera, Preview and so forth)

It also starts without any windows after I have clicked "default" under Preferences/Apperance...

Is there are way to reset the interface preferences, or delete them. I have the feeling it might have been corrupted. Any ideas?

Thanks for your input

Q2

Re: Maxwell Render - Interface Windows Setup Problem

Posted: Fri Oct 12, 2012 2:20 pm
by polynurb
the -h key hides all windows. maybe it got stuck in that mode.

try opening, press -h and close>reopen

-daniel

Re: Maxwell Render - Interface Windows Setup Problem

Posted: Fri Oct 12, 2012 2:47 pm
by Q2
DANIEL! That did it..... boy, I was a bit blind on that eye! I usually know to press -h but somehow that didn't cross my mind!

THANKS A LOT!

:D :D :D

Q2