Page 1 of 1
Wizard question
Posted: Tue Nov 23, 2010 5:26 pm
by Asmithey
Hi,
I used the wizard to create Nickel. It created a one BSDF material. The one BSDF which was created has a weight of 60. I am curious why the weight of the one BSDF is not 100 since it is not blending with another BSDF.
Thanks for any insight.
Aaron
Re: Wizard question
Posted: Tue Nov 23, 2010 5:33 pm
by Bubbaloo
Tom is the guy to answer this question. But I can give you a tip on metal creation that the wizard doesn't do: duplicate the BSDF at a lower weight (20) and a small amount of roughness (5 or 10).
Re: Wizard question
Posted: Tue Nov 23, 2010 5:46 pm
by Half Life
If you input a higher roughness an additional BSDF will be created and blended.
Best,
Jason.
Re: Wizard question
Posted: Tue Nov 23, 2010 5:48 pm
by Bubbaloo
Half Life wrote:If you input a higher roughness an additional BSDF will be created and blended.
Best,
Jason.
Cool, I didn't know that!
Re: Wizard question
Posted: Tue Nov 23, 2010 7:06 pm
by Asmithey
I see. Thanks. I did not want a 0 roughness anyway. I guess I just breezed over that. I just changed the roughness after the fact. So I guess I am rendering with an incorrect material. I will recreate it setting the roughness in the wizard.
Aaron