Maxwell Render | Official public forum

Posted: **Thu Dec 08, 2005 5:49 pm**

Hi there,
I'm so happy for the C4D plug!

But I think I found a buggie.
I have the impression (not too much time to check it thoroughly) that if you assign a material to a Extrude NURBS object with more than one splines (hierarchical mode), the M~R material doesn't get applied.

Can anybody check it?

Thanx!

Posted: **Thu Dec 08, 2005 6:08 pm**

I think I have concluded that when you have the "hierarchical" switch ON, it ignores the maxwell material you assign.
I will have a 100% answer in a few minutes...

Posted: **Thu Dec 08, 2005 6:09 pm**

Just Confirmed it.

May Day May Day we have a bug...

Posted: **Fri Dec 09, 2005 5:10 am**

Thanks for the bug report.

This one may fall under the current problem of deformers and nurbs not transferring properties to child objects such as the render visibility dot.

I just confirmed this one.

Thanks noseman.

This bug is known as N15 and appears in the CIRI 0.7c.

ref: http://www.maxwellrender.com/forum/view ... 5677#95677

Maxwell Render | Official public forum

Bug N15: Nurb Objects do not pass material to child objects

Bug N15: Nurb Objects do not pass material to child objects