Page 1 of 1
preventing converging verticals in architectural perspective
Posted: Fri Apr 10, 2009 4:21 pm
by Josephus Holt
Is this option available in either the Maxwell camera or C4D...or Rhino?
I know this can be done with postwork in PS...in which case I would need to allow a bit more image to compensate for the cropping.
Posted: Fri Apr 10, 2009 4:43 pm
by Mihai
Use the Shift Lens feature, just make sure the camera and camera target are at the same height to get a 2 point perspective, then shift the image up/down using the Y value of the Shift Lens.
Posted: Fri Apr 10, 2009 4:53 pm
by Josephus Holt
Ahhh, use "target camera"...not "camera"..... too easy...
thanks Mihai
Posted: Mon Apr 13, 2009 10:33 am
by zoppo
you don't have to use a target cam -
just make sure the cam's p-axis is set to 0°
Posted: Mon Apr 13, 2009 3:18 pm
by Josephus Holt
Thx Zoppo....got it, is even easier not using target camera