Page 1 of 1
wrong camera export
Posted: Fri Nov 14, 2008 8:03 pm
by spekoun
When i export scene camera is very wide. When I open scene in studio, everything looks fine. Only thing I found ou which can correc camera is Film Back. I have to correctit to W=0.032. Then is camera same as in C4D. Do I something wrong, or is it a bug?
Posted: Fri Nov 14, 2008 9:46 pm
by JDHill
There's a previously-reported bug where the perspective will be off (i.e. film back is wrong) when the output resolution has a portrait aspect ratio - does this sound like the same thing you're seeing?
Posted: Mon Nov 17, 2008 12:21 pm
by spekoun
Maybe. But perspektive is wrong ragrdless of aspect ratio. I set resolution 1800x1200 and 1280x720. Perspective was wrong in both cases. I opened scene in studio corrected film back and persp was fine.
Posted: Wed Nov 19, 2008 5:14 pm
by zoppo
Do you use "write mxs" for export?
This seems to export the "Active View" and not the "Render View", which is very inconvenient for network use.
Posted: Wed Nov 19, 2008 6:08 pm
by JDHill
You're right - this is an oversight - I'll make sure it uses the Render View resolution when just writing MXS files in the future. About the original issue Spekoun, thanks - I was able to duplicate this on 1.8 CTP using your 1800x1200 example. I didn't dig out the old code to figure out why, but lots of things have been tweaked here since the release and it is working fine on my current code.
Posted: Fri Dec 05, 2008 3:06 pm
by tennet
I am also experiencing problems with the camera when rendering with the new 1.8 plugin. I use a camera in portrait mode (21x30 cm 200 dpi). Attached is a test file I did that shows how much more cropped the rendered image is compared to the camera in the viewport. Same problem when using the new "render region"-tag. The selected region is much more cropped when rendered.
I am using Cinema R11 on Mac OSX. I am rendering directly from Cinema using the "Selected render view" (R).
// tennet
Posted: Wed Dec 10, 2008 10:55 am
by Assistant
Hi
Sitting also on Mac and Cinema R11 with 1.8 plugin. As "Tennet" says I have the same problem. This just gives me the problem when Im going to render an interior but good with reference points so i can zoom out to get the right/same perspective.
Also using the function "Selected render view"
Posted: Wed Dec 10, 2008 12:18 pm
by JDHill
Thanks, it will be fixed in the next version.
Posted: Wed Jan 07, 2009 4:25 pm
by tennet
When will the next version be released?
Posted: Wed Jan 07, 2009 6:11 pm
by JDHill
asap - it's ready to go.
Posted: Wed Jan 07, 2009 8:42 pm
by jespi
Thanks for the info Jeremy.
Cheers,
José
Posted: Sat Jan 10, 2009 2:58 pm
by adri
can we have the new plugin please?????
TIA
Adri