[thomas lacroix]

did someone find out where to choose wich camera for rendering with the plug? i did put 2 but couldnt choose anywhere...
any hints?

[Ric_535]

in the maxwell render settings under camera / render camera, if you have for example 2 cameras in your scene but only one is showing up in the options then change your C4D layout to something different and then back again, after that both cameras should turn up in the maxwell settings

[Tyrone Marshall]

The way the camera is chosen for the plugin for version 1.1 has changed. Check out the manual for full explanation but basically the plugin takes its view from the active viewport, this could be from a camera or just using the editor - only perspective views work, no orthagonal views such as east, west, and north, etc.

Directly from the Cinema 4D user manual page 5:

The camera used to render is the selected view camera, whether it is the editor camera or a ‘real’ camera.

The projection must be perspective, orthographic or non-perspective cameras or views are not supported at this time by Maxwell Render.

[macray]

may I ask how the DOF is chosen if we take the editor camera? Which point is the focus on?

[thomas lacroix]

sure if i could read the manual i would, i dont have word and wordpad cannot convert something in the file...so i cant read the manual
html anyone?

[macray]

you got mail..... pointing to a PDF-file

[thomas lacroix]

thanks macray, i'm reading it now

[dd_]

i was wondering the same thing macray , ie about the DOF of the perspective view port. any one ??

[Eric Lagman]

I also could not open the wordpad document for some reason Edit: Nevermind got it to work on my work pc.

[Tyrone Marshall]

DOF in C4D is controlled by the camera target that is part of the C4D camera object attributes (do not use target object) - you can even turn on front and rear as well to further define DOF.

[dd_]

thanks tyrone

[macray]

DOF in C4D is controlled by the camera target that is part of the C4D camera object attributes (do not use target object) - you can even turn on front and rear as well to further define DOF.

I know but that's exectly the reason why I'm wondering about the editors view. I don't have a certain focus and DOF there. no back and front. I just have the view with no camera and NO target at all. How is the Focus calculated? (is it 0;0;0 or something else?)

[Tyrone Marshall]

DOF in C4D is controlled by the camera target that is part of the C4D camera object attributes (do not use target object) - you can even turn on front and rear as well to further define DOF.

I know but that's exectly the reason why I'm wondering about the editors view. I don't have a certain focus and DOF there. no back and front. I just have the view with no camera and NO target at all. How is the Focus calculated? (is it 0;0;0 or something else?)

Good point, Macray- with just the editor you have no focus control or DOF that I am aware of. I would fine tune it in Studio - there you could use the autofocus and focus to - feature.

[macray]

I still try to avoid Studio as much as I can. I use the material editor and nothing more except the plugin.

And therefore I switched to use a camera again to get a focus on the area I want to have in focus.

Sorry, but I don't want to use Studio. It should be enough to have one program to use where I can set up everything - so I don't want to do it all over again in Studio after I did it in C4d.