Maxwell Render | Official public forum

(sorry for my english ,but it is very diffucult for me to explain my problem in correct english )
-----------------------

after my renderjobs finishes i turn on the glare,and i see the nice glare effect in the preview window ! ( and only threre)

so far so good,but how can i add the glare effect i see in the preview to the main images above because its still without the glare?

In RC5 i had to push the refresh button and after a while the main Images was altered. but in the new release it didnt work ?

in the maxwell 1.0 pdf show me a different Preview window with differentoptions like i see. how can i access these options ?

ok again !!!
,if i change after the render stops the light,or add glare,so how
can i made the the changes to the main render images,not only to the preview,and why i dont see the restore and maintain values button in my
c4d plug in window?



my preview Window

and the preview window in maxwell 1.o pdf

thanks

if you are using -ml than the glare effect shows only in preview window, otherwise after refreshing it will update the main pic

hope it helps

kizo wrote:if you are using -ml than the glare effect shows only in preview window, otherwise after refreshing it will update the main pic

hope it helps

thanks,i turn off the -multilight and it seems it doesnt matter ,no change
its the same as before,preview window shows the effect but after refreshing preview the main image is still without the effect