Maxwell Render | Official public forum

when a node disconnects from a job, its status remains "disconnected" forever.
It's not possible to refresh the display even if the node is added to the job again.
A proper status report and refresh would be really helpful...

It would be nice to be able to remove a node from the job, but keep the mxi (transfer it to the manager) and then clear its status...

numerobis wrote:when a node disconnects from a job, its status remains "disconnected" forever.
It's not possible to refresh the display even if the node is added to the job again.
A proper status report and refresh would be really helpful...

It would be nice to be able to remove a node from the job, but keep the mxi (transfer it to the manager) and then clear its status...

Yep.

I'm noticing this same behavior as well.