Page 1 of 1
Newly designed yoke for flight simulation
Posted: Thu Dec 22, 2022 10:08 am
by NicoR44
Hi all, here a new yoke I made in Solid Works, to be die casted in a silicone mold.
overall Thickness is 7mm, rendered in green glass using the default Maxwell studio, light setup studio
Cheers, Curt.
Render time on my system about 16 hours
Re: Newly designed yoke for flight simulation
Posted: Thu Dec 22, 2022 10:56 am
by NicoR44
Re: Newly designed yoke for flight simulation
Posted: Thu Dec 22, 2022 11:06 am
by NicoR44
Re: Newly designed yoke for flight simulation
Posted: Thu Dec 22, 2022 4:58 pm
by choo-chee
very nice materials
Re: Newly designed yoke for flight simulation
Posted: Fri Dec 23, 2022 12:36 am
by Mark Bell
Well done - the green-glass renders explain the proposal clearly. Good work. Out of interest, what was the SL you rendered to?
Re: Newly designed yoke for flight simulation
Posted: Tue Dec 27, 2022 1:46 pm
by Forum Moderator
Very nice and clean, Nico!
I'd say that he's using some big emitters and we are not seeing the full-res render so, most probably, it only went up to SL 16-17.
Fernando
Re: Newly designed yoke for flight simulation
Posted: Fri Mar 03, 2023 2:14 pm
by NicoR44
Re: Newly designed yoke for flight simulation
Posted: Fri Mar 03, 2023 8:37 pm
by Tea_Bag
Great work as always Nico! I really like the glass material
Re: Newly designed yoke for flight simulation
Posted: Tue Mar 07, 2023 10:55 am
by NicoR44
Thank you so much!!