Page 1 of 1
Interior renderings
Posted: Thu Feb 21, 2013 8:38 am
by Asmithey
Here are some interior renderings....Carpet could be better. Some of the wood is not textured the best either. Ran out of time. Client is happy though.
Modeled in Blender using the Bmaxwell add-on.
Re: Interior renderings
Posted: Thu Feb 21, 2013 6:11 pm
by Bubbaloo
Nice job!
Re: Interior renderings
Posted: Thu Feb 21, 2013 6:17 pm
by gadzooks
Very Nice. Did you use IES for the cans? They look very convincing.
Re: Interior renderings
Posted: Fri Feb 22, 2013 1:21 am
by Asmithey
Thanks guys.
No ies data for the lighting. I seem to keep forgetting to use ies data. This would have been a good time to try it. Next time I will do that. The emitters are just tiny square planes.
Re: Interior renderings
Posted: Fri Feb 22, 2013 4:49 am
by gadzooks
Asmitey mind showing how you set up the emitter to get it to scallop on the wall? I can never seem to get mine to do that. When you say small plane how small? I wonder if that makes a difference.
Re: Interior renderings
Posted: Fri Feb 22, 2013 6:53 am
by Asmithey
I have a cylindrical opening in the ceiling with the small square plane inside. I rotate the emitter about 30 degrees towards the wall. My emitters are 1" square planes.
Aaron