Page 1 of 1
Maya not chosing all my vertex!?!?
Posted: Mon Jun 27, 2005 1:33 am
by DIA
i have a big problem...
When iam gonna do a fullscale building for example and i need to choose some vertex from top view i only get the top ones and not the other ones below ... why ?? my farclip plane is set to 100000.000 is this right ???
Posted: Mon Jun 27, 2005 7:10 am
by idas
this is not maxwell for Maya question !!!
Check Maya manual. plz
Posted: Mon Jun 27, 2005 7:51 pm
by DIA
hmm thx for your big help m8!
Posted: Mon Jun 27, 2005 8:39 pm
by iker
idas wrote:this is not maxwell for Maya question !!!
Check Maya manual. plz
hey man! be friendly!
DIA, is it your building just one object?
...have you try with 100000000000 far clip plane?
...how about near clip plane?
Posted: Mon Jun 27, 2005 8:50 pm
by DIA
hey iker !
i havent tried anything more than 100000.000 for far clip and the near clip is on default settings...
Has it something to do with it do you think ?
Yea its one object its a house and when i need to change the vertexes from top view it only chosing the ones on the top ..
(i´ll be here soon again gonna play some bf2 just to relax a little bit from maya and maxwell for a couple of minutes)
Posted: Mon Jun 27, 2005 11:02 pm
by iker
DIA, is your model so big?
I think it can be Near/Far clip planes, it happened to me once in a project and I think it was the Near/Far clip planes (not sure sorry, was in Maya 2
)
Posted: Tue Jun 28, 2005 2:16 am
by DIA
hmm mayby i have the wrong scale settings .hmm.. if i have i used the wrong scale setting all the time
Posted: Tue Jun 28, 2005 9:19 pm
by DIA
thx sven !
i will try that
Posted: Tue Jun 28, 2005 9:52 pm
by 3dtrialpractice
also a quick note, try turning off the grid in the view , I found sometimes my icons or other things such as vertexs may not show always through the grid.
Posted: Wed Jun 29, 2005 12:39 am
by DIA
thx m8 ! i tried that and it works !