Maxwell Render | Official public forum

Posted: **Sun Feb 25, 2007 2:14 pm**

Hi

Thumbnails are as follows...the originals are about 800px square

The editor setup

The output

So it's completely missing the texture and bump map. Can anyone help? Also any suggestions for good technique in making stone textures would be great.

TIA

Adri

Posted: **Sun Feb 25, 2007 2:29 pm**

turned on xy tiling and it's now appearing in the render. However, any tips on producing a stone type material would be welcome as at present it doesn't look that brilliant...

For reference the stone is a hard gritstone covered in lichen.

TIA

Adri

Posted: **Sun Feb 25, 2007 2:36 pm**

did You check some stone samples over at the mxmboard?

http://mxmgallery.maxwellrender.com/

there are some super stones around ...

?

Posted: **Sun Feb 25, 2007 3:10 pm**

Hi

Thanks for the tip deadalvs. I'm more or less copying settings from the Arroway sandstone. Seems a reasonable way to learn.

One problem I'm having is when I load a map into the editor I get this

For some reason the map isn't showing right in the editor.

Any ideas?

TIA

Adri

Posted: **Sun Feb 25, 2007 3:23 pm**

Adri...

Make all your maps RGB (yes even the greyscale ones like your bump map..)... and all will be fine..

hope this help..

Maxwell Render | Official public forum

First material attempt. bump map and material not showing..

First material attempt. bump map and material not showing..

Reply to myself

Problem with the MXM Editor