Page 1 of 1

My Bathroom WIP

Posted: Fri Nov 14, 2008 6:43 pm
by Cloudman
My wife was struggling to "see" our new bathroom, mainly because I've not started it yet. I thought I'd make some headway by showing her what it could look like......I guess I need to spend less time in my virtual world :lol:

I'm a product designer, so am not used to interior design/visualisation ....my work's normally on a much smaller scale. Had lots of fun playing with multilight for the first time.....what a great tool!

Not sure why the glass in the picture frame is so noisy. These got to around sl15. Any advice welcome.

Image

Image

Image

Image

Image

Image

Image

Image

Image

Posted: Fri Nov 14, 2008 7:42 pm
by djflod
nice renders :)

i like the one with black tiles most. Nice sink :D

Posted: Fri Nov 14, 2008 7:50 pm
by Cloudman
djflod wrote:nice renders :)

i like the one with black tiles most. Nice sink :D
My missus thinks this one looks too much like a night club :roll:

Posted: Fri Nov 14, 2008 8:02 pm
by djflod
:lol: :lol: :lol:

Posted: Sat Nov 15, 2008 9:24 am
by Hervé
nice... but just one sink..? hehe it does look like a club men's room... 8)

Posted: Sun Nov 16, 2008 3:49 am
by ivox3
The black tiles are sweet.

That can't be how the shower pan is really going to be ?

Posted: Sun Nov 16, 2008 11:38 am
by Jan
Nice renders Cloudman. Only a bit strange effect: in the fourth and fifth images, the mirror appears like clone instead of mirror when reflect the light :?

Posted: Sun Nov 16, 2008 5:43 pm
by lebbeus
as Ivox points out: you're going to have problems with the shower pan (floor of the shower). If you don't want your entire bathroom to be a "wet zone" (this is totally possible, but requires different construction detailing) then you'll need a "curb" at the edge of the shower--this will help contain the water. The shower door also may be problematic given that it appears to be flush with the edge of the "pan"; it may need to be offset (towards the shower) a bit so that you can have the gaskets installed. Minimal detailing looks deceptively simple--it's actually much more complicated and more expensive to hide the necessary elements of construction---hopefully you have an Architect helping out. . .

what are the settings for your porcelain? in some of the images it appears a bit too reflective/luminous; like you're using a dual-layer BSDF with additive mode and 100/100 weighting. (I ask because I just did this on a project without thinking and got some funky results)