Maxwell Render | Official public forum

Firstly I must say I am not as good as most of the users on this forum. Secondly, I know these images are not fully complete, however they have served the purpose they were meant for.

The image with cup was done with Cinemaxwell only and the metal balls was done with VectorWorks and DXF exported to Studio.

[img=http://img3.freeimagehosting.net/upload ... 4c195d.jpg]

[img=http://img3.freeimagehosting.net/upload ... fb0110.jpg]

Any C&C are most welcome cause I learned a lot from the users on this forum. Lots of thanks to everybody.

looking really good, shaun !

don´t know why you say you´re not that good...
at least you did a very convincing job on this one !

not everyone can be such a beast as keytoon...

I know these images are not fully complete

looking complete and polished to me mate. great renders.

Thanks guys. Yeah guys like Keytoon really make me think twice about posting images. They have so high standards. Sometimes it can be a bit embarrasing. But on the other hand they inspire me and I love looking at images created by all maxwell users. Thanks again to everybody.

Just wanted to say that the images don't load for me right now, i'll check back later

They look pretty good to me - nice work Shaun

BTW, the images don't show up for me unless I click on the image placeholders... then I go to the link.

-Greg