Maxwell Render | Official public forum

I always adjust the f/s setting in the maxwell interface. Is there a way to adjust it in Lightwave so that it defaults to 30 instead of 60?

I can adjust DoF in Lightwave's interface but I set ISO in the maxwell window. WHere can I set f/s in Lightwave so that I need not adjust it after the render starts?

How do other programs (maya, max) make this setting?

in max fstop (along with shutter speed) can be set in the camera rollout. ISO is under tone mapping (along with burn) in the renderer dialog.

Maxwell uses all parameters of native LW camera. If you check motion blur in LW camera panel, you can adjust shutter speed the way you like. More flexible than Maxwell interface.
HD