Maxwell Render | Official public forum

I'm in a bit of a tight spot here. I was given a rush job (needs to be done tomorrow), and it has lots of neoprene and fake leather (vinyl) stuff that is supposed to be black - and stay black when I light it.

I'm having troubles getting my materials to not reflect a whole bunch of light and 'brighten' on me. I realize that I must be doing something terribly wrong, but I'm not figuring it out.

Any suggestions?

Thanks,

ernchesto

Well, basically start with setting 'Reflectance 90' to 0,0,0 - Black.
And here's what you get:

Is that what you're after?

Yeah, thanks. I'm making progress - but I'm having a hard time using textures and keeping the 'blackness'. Can you tell I've been away from Maxwell too long!

Thanks for the help.

Cheers,

ernchesto

If you're using just a simple neoprene texture, it would be easier to use a bump map instead of texture.

Neoprene has 2 different attributes

1. A pretty rough diffuse surface which is rather dull, sucking in light
2. A little specular / reflective part that gives a rather smooth shine to it

Perhaps generate a map to put into the roughness channel of a Specular BSDF weighted at around 10-20 percent using something like 20-35 Roughness for the smooth shine

Actually Tom made a pretty good tutorial on how to use Arroway textures with this technique and I think you will learn to understand the way to get detail by reading it.

You can find it here

Hey thanks a lot for your comments folks. It's quite helpful.

Funny how much reading one always seems to have to do around a deadline!

Cheers,

ernchesto

It helps disecting materials into its basic components when starting research for a job