#182899
I am working with 3d volumes and sometimes with simple flat surfaces, to recreate the ground plane, and other stuff.
The problem is that Maxwell cannot see these simple faces when seen from the side, or front, in case of a ground plane, but only from top.
At least a simple line should be seen, in order to have all the information in the 2D viewports.

Ernesto
is Maxwell Render abandoned?

Hello there..... I´ve been out of this forum[…]

Maxwell licence on new computer

Thank you very much Nasok! This explanes a lot. I[…]

Bubbles in glass

Hi Márton My apologies for the delay reply[…]

Rhinoceros 6 support

Hello Nicola, OK, I will add the layer group expor[…]