Maxwell Render | Official public forum

Posted: **Sat Aug 04, 2007 1:14 am**

Hi Pavol,

I noticed that there is an odd rotation when I transfer my scene from ArchiCAD into Maxwell Studio with the plug-in. I checked all the settings, but could not figure out what the reason might be.

Could you please check it and let me know what a solution could be? It is quite important in order to set up similar scenes in Studio and ArchiCAD.

Thanks!

Adam

Posted: **Sat Aug 04, 2007 2:01 am**

If you check the object param panel in Studio, does it have any rotation value? Or is it 0 and it comes in rotated like that?

Posted: **Sat Aug 04, 2007 5:26 am**

Hi Mihai,

The values are 0

see screen shot:

Posted: **Tue Aug 07, 2007 4:14 am**

Does anyone have an idea about the solution?

Posted: **Wed Sep 12, 2007 2:26 pm**

My best guess is that is camera related. Your images show floor plan (2D view) thus I have no information what is the camera setting in your case. Switch to 3D view in ArchiCAD and Maxwell view will match it. The perceived "rotation" you are mentioning is most likely due to a default 3D projection settings.

Pavol

Posted: **Sat Jun 21, 2008 3:15 am**

This seem to have dissapeared with the 1.7 add-on too. Good job again Pavol!

Maxwell Render | Official public forum

Odd rotation by plug-in transfer

Odd rotation by plug-in transfer