Page 1 of 1
Protected Geomtry
Posted: Fri May 25, 2007 3:55 pm
by Daniel Hruby
Is there anyway to have an option to "Unprotect Geometry" for further export from Studio? Right now any attempt to export a model for studio in OBJ format says it can not proceed as the geometry is protected.
Posted: Thu May 31, 2007 2:08 pm
by pelias
As far as I know such option is not available - I will ask Studio developers though to confirm that.
Pavol
Posted: Thu May 31, 2007 2:44 pm
by pelias
OK - I was wrong
All the exported geometry is protected by default but there is an option in Maxwell SDK to disable the protection. However this is not supported by ArchiCAD plugin at the moment - I will add it to the next version of the plugin.
Pavol