User avatar
By Daniel Hruby
#227853
Is there anyway to have an option to "Unprotect Geometry" for further export from Studio? Right now any attempt to export a model for studio in OBJ format says it can not proceed as the geometry is protected.
By pelias
#229980
As far as I know such option is not available - I will ask Studio developers though to confirm that.

Pavol
By pelias
#229992
OK - I was wrong :-)

All the exported geometry is protected by default but there is an option in Maxwell SDK to disable the protection. However this is not supported by ArchiCAD plugin at the moment - I will add it to the next version of the plugin.

Pavol
is Maxwell Render abandoned?

Do you mean that jazz tune that sounds like Jolly[…]

FormZ 9 support

Please, PLEASE keep up support for FormZ. It's a k[…]

Maxwell Render 5

Good question. Their was a link in the announceme[…]

after quitting because the LW plugin was discontin[…]