Maxwell Render | Official public forum

Hi There,

I have a crash that is driving me nuts. I have a scene called "vplow_straight.mxs". I have set this up with materials and I can open it just fine. I have another freshly-exported scene (from Solidworks) called "vplow_forward.mxs". I want to apply all of my material assignments to this new scene (just the position of components have been moved) and render it. So I do the following:

- Open "vplow_straight.mxs" in Studio.
- File > Import To Scene, and choose "vplow_forward.mxs"
- Crash at 28% complete every time.

I can open "vplow_forward.mxs" just fine. Any ideas on this one? I am using RC5. A zip of the files in question can be found here:

http://www.digitalwizardry.ca/markm/plo ... _crash.rar

My email address is mark dot melvin at gmail dot com.

Thanks a lot,
Mark.

Hi mark,

I have checked that both scenes are properly loaded in the current internal version of Studio. A lot of bugs in the import files area have been fixed. Thanks a lot for your report.

Juan


[img][img]http://img134.imageshack.us/img134/3236/nocrash5rh.jpg[/img][/img]

[img][img]http://img134.imageshack.us/img134/2106/nocrash20pz.jpg[/img][/img]

Hi Juan,

Did you manage to import the second scene "into" the first one, and keep all of the material references (but replace all of the geometry)?

Thanks for looking at this,
Mark.

Hi Mark,

mark_melvin wrote: Did you manage to import the second scene "into" the first one, and keep all of the material references (but replace all of the geometry)?

In the current internal version of Studio I have done it fine. All the import methods have been further enhanced for the next version.

Regards,

Juan

Thanks a lot, Juan.

M.