Page 1 of 1
render region available through plug in?
Posted: Fri Dec 05, 2008 6:44 pm
by Gary
Hello:
it would be great if we could access the render region tool through the form z plug in.
Gary
Posted: Fri Dec 05, 2008 7:49 pm
by pelias
As far as I know formZ doesn't have render region tool itself - that makes it harder to develop one for Maxwell. It might be still possible, I will investigate this further.
Pavol
Posted: Fri Dec 05, 2008 9:41 pm
by medmonds
FormZ DOES have a render-region ability... it's a little checkbox under the options for Renderzone called "set image size." Although this doesn't sound like a render-region type of option, it is.
Posted: Fri Dec 05, 2008 10:29 pm
by Gary
Hello Pavol:
Matt is correct about the "set image size" in formZ. The only downside to their implementation is that it will only render at screen resolution.
Gary
Posted: Fri Dec 05, 2008 10:31 pm
by pelias
I see - I wasn't aware of that...
I will check SDK whether it is accessible for Maxwell plugin. If it is, than the implementation should be simple.
Pavol
Posted: Fri Dec 05, 2008 10:34 pm
by Gary
Pavol:
is it possible to have an option for the plug-in to pre-compute the changes in focal between Z and Maxwell as discussed here:
http://www.maxwellrender.com/forum/view ... hp?t=27743
Thanks,
Gary
Posted: Sat Feb 28, 2009 1:02 am
by Gary
Hello Pavol,
any new information on the 2 issues mentioned in this thread—
1. render region from form-z plug-in
2. pre-compute the changes in focal length between Z and Maxwell
Thanks,
Gary